Using Epc Process Can Produce Most Of The Ductile Iron Castings And Manganese Steel Castings

Using epc process can produce most of the ductile iron castings and manganese steel castings, not suitable for production of low carbon  steel and casting wall thickness less than 3 mm. 

Common ductile castings used lost foam process are: manhole cover、shaft frame、water 

pump, bent axle, steel cap, butterfly valve chip, dismemberent, traction seat, pipe fitting, valve etc.

Common high manganese steel castings used epc process are: hammer, wearresisting ball, sieve plate, clevis, wallboard, caleboard etc.

Lost foam productions are:

 1. Automobile parts:  rear axle、wheel hub、shell（box）, air cylinder, cylinder cover, drain-pipe, water inlet  

2. Mine cement class:  ball mill line grinding head plate, parting board discharging sieve plate, refractory steel, jaw plate, hammer, mining accessories

3. Engineering machinery and  coal machinery: bucket teeth, bucket tooth, blender, chute liners, scraper blade

4. Non-ferrous metals and aluminium: anode steel claw, cast copper, cast aluminium

5. Metallurgical industry: the blast furnace water-cooled grate, hot gas article, integrated structural parts

6. Chemical industry: corrosion resistant steel, calcium carbide pan, heat resistant castings of coking plant series

7. Pump water supply and heat supply: up and down the pipe, mesohigh heater, water pump, grinder

What's your production, could you please send it to me, I will let our casting engineer analyze it for you, and tell you if it is suitable with lost foam casting process.

Waiting for your reply!